1.1.3 build 2955

Fix: Change help contents for sso command line to show units at authtime
Fix: Fix POP3 Proxy scanning that was broken in build 2954
Fix: Correctly show running firmware immediately after install or after selecting an older version
Fix: SSO authentication fails unexpectedly after a random time
Fix: Better link status check on multiple gateways (more resilient to packet loss on low quality lines)
Fix: Show multilink status when using ‘config gateway show’
Fix: No longer block messages when scanning errors occur (only notify administrator and quarantine message for investigation)
Fix: Enabling only one custom category in Web Content Filter profiles causes strange behavior
Fix: Sometimes antivirus updates stop and fail to restart unless manually restarting the update process
Fix: Update OpenSSH to address CPNI-957037 Plaintext Recovery Attack Against SSH
Fix: Webproxy fails to apply configuration when using definitions that contain spaces
Fix: Allow dots in email addresses’ username part when sending email from quarantine
Fix: Improved checks when using multiple gateways and changing IP address
Fix: Improve HA monitor daemon to use less memory in certain circumstances
Fix: Delete gateway fails on multipath setup
Fix: Prevent blocking of POP3 mail boxes when an email inside cannot be scanned
Fix: Prevent SMTP problems with many error emails in quarantine
Fix: SMTP proxy now logs email sender information even when envelope “Received” field is missing
Fix: Fix IPSec dead peer detection (DPD) with a peer behind NAT or using a dynamic IP address
New: Selecting an older firmware version will automatically configure it to start by default
New: Add option to Drop and Quarantine SPAM messages
New: Multiple actions for SPAM messages (Allow admin to specify ‘Drop’ and ‘Quarantine’)